Stage Straps  presents ...
Chrome Studded Mud Flaps for Tractor Trailer Trucks
chrome studs

mud flaps


These are
heavy-duty,
3/8" extra thick,
24" x 30"
black rubber
mud flaps
which come with
embedded
3/4" chrome studs
and attached
chrome
bottom plates.
They are
$130 per pair
including S/H
to anywhere
in the U.S.

truck mud flap

(chrome crosses, skulls, mudflap ladies, etc. can be added)

These mud flaps have also been attached to large pick-up trucks.

truck mud flap truck mud flap


truck mudflaps truck mud flap

Add Chrome Top Plates + $20, Lightning Bolts + $20, Letters + $20, Stainless Steel Anti-Sail Panels + $40.

The mud flaps measure 23.5" x 30.5" (commonly referred to as 24" x 30" mud flaps) and can be cut to angled hangers (see below.) The tire side of the mud flap has the Chevron style rain guard pattern.


To place an order or if you have any questions
contact Joel at the email address:

email

(Joel 9 x x x at yahoo.com)  (I do not provide email links because of "spambots")
or you can send an email to me in the box below
(type in box and click button below it.)

FOR AN EMAIL RESPONSE, YOU MUST INCLUDE YOUR COMPLETE
AND CORRECT EMAIL ADDRESS IN YOUR MESSAGE ABOVE.

I make studded belts and guitar straps.
When I see a cool looking tractor trailer truck I always think,
"That truck would look great with studded mud flaps." So here they are.

Mud flap accessories such as chrome crosses, skulls, mudflap ladies, etc., can be
ordered from suppliers such as Empire Chrome and America's Truck Wash & Chrome Shop.


To cut the mud flaps to angled hangers...

The mud flaps can be cut with a sharp utility knife (if there is a stud in the way of your cut, it can be yanked out with pliers.)

If you want me to pre-cut the mudflaps to angled hangers, I will need two measurements as follows which you can work out from your current hangers or mud flaps: A horizontal measurement from the inside top edge of mud flap to point where cut should start; and a vertical measurement from the outside top edge of mud flap to point where cut should end. For example, facing the outside/design side of the left mud flap, I will use your horizontal measurement to measure across the top of the mud flap from the top right corner to the point where cut should start, and I will use your vertical measurement to measure down the side of the mud flap from the top left corner to the point where cut should end.


Here is one cool truck, photo courtesy of StacksnCracks.com ...
tractor trailer truck